AT Command Reference Guide for EDGE Wireless ... - wless.ru

Chapter 12 – FAX Commands
12.7 AT+FTM Transmit Data
Description:
The AT+FTM command causes the TA to transmit data using the modulation mode
defined in Section 12.1, FAX parameters. An ERROR response code results if this
command is issued while the modem is on-hook.
Test Command Syntax: AT+FTM=
Response:
(list of s)
OK
Write Command Syntax: AT+FTM=
Response:
CONNECT
If error is related to ME functionality
ERROR
Notes:
• Used for Fax Class 1 only.
• = 3 is not possible.
12.8 AT+FTS Stop Transmission and Wait
Description: This command causes the TA to terminate a transmission and wait for 10
millisecond intervals before responding with the OK result code to the DTE.
Write Command Syntax: AT+FTS=
Response:
An ERROR response code results if this command is issued while the modem is onhook.
Parameter Description:
no. of 10 millisecond intervals
0...85
Note: Used for Fax Class 1 only.
Multi-Tech Systems, Inc. AT Commands for EDGE Modems (S000371B) 170