AT Command Reference Guide for EDGE Wireless ... - wless.ru

Chapter 19 – Miscellaneous Commands
Chapter 19. Miscellaneous
Commands
The AT Commands described in this chapter are related to various areas.
19.1 A/ Repeat Previous Command Line
Description:
Repeat previous command line.
Exec Command Syntax: A/
Response:
NA
Notes:
• Line does not need to end with terminating character.
• After beginning with the character “a” or “A” a second character “t”, “T” or “/” has to follow. In case of using a
wrong second character, it is necessary to start again with character “a” or “A”.
• If autobauding is active, the command A/ cannot be used (see AT+IPR).
19.2 ATS3 Set Command Line Termination
Character
Description:
The ATS3 command determines the character recognized by the TA to terminate an
incoming command line.
Read Command Syntax: ATS3
Response:
OK
Write Command Syntax: ATS3=
Response:
OK
ERROR
Parameter Description:
Command line termination character
000.....127 Default = 13.
Notes:
• Using a value other than the default 13 may cause problems when entering commands.
• Whenever you change the setting, take into account that the new value has no effect on the URC
“^SHUTDOWN”.
19.3 ATS4 Set Response Formatting Character
Description:
The ATS4 command determines the character generated by the TA for result code and
information text.
Read Command Syntax: ATS4
Response:
OK
Write Command Syntax: ATS4=
Response:
OK
ERROR
Parameter Description:
Response formatting character
000....127 Default = 10
Note:
Whenever you change the setting take into account that the new value has no effect on the URC
“^SHUTDOWN”.
Multi-Tech Systems, Inc. AT Commands for EDGE Modems (S000371B) 232