AT Command Reference Guide for EDGE Wireless ... - wless.ru

Chapter 11 – GPRS Commands
11.8 AT+CGEQREQ 3G Quality of Service Profile
(Requested)
Description: The test command returns values supported as a compound value.
The read command returns the current settings for each defined context.
The write command allows the TE to specify a Quality of Service Profile for the context identified
by the (local) context identification parameter which is used when the MT sends an Activate
PDP Context Request message to the network.
A special form of the write command, AT+CGEQREQ= causes the requested profile for
context number to become undefined.
AT&F and ATZ will undefine the QoS profiles of every context which is not active or not online.
Test Command Syntax: AT+CGEQREQ=
Response(s):
+CGEQREQ : , (list of supported s), (list of supported
s), (list of supported s), (list of supported
s), (list of supported s), (list of supported
s), (list of supported s), (list of supported s), (list of supported s), (list of supported s), (list of supported s), (list of supported s)
OK
Read Command Syntax: AT+CGEQREQ
Response(s):
[+CGEQREQ: , (list of supported s), (list of supported s), (list of supported s), (list of supported s), (list of supported s), (list of supported s), (list of supported s), (list of supported s),
(list of supported s), (list of supported s), (list of supported s), (list of supported s)]
[+CGEQREQ: ...]
Write Command Syntax: AT+CGEQREQ=[[, [, [, [, [, [, [, [, [, [, [, [, ]]]]]]]]]]]]]
Response(s):
OK
ERROR
+CME ERROR
Parameter Descriptions:
Parameter specifies a particular PDP context definition. The parameter is local to the TE-MT interface and is
used in other PDP context-related commands.
1...2
0 conversational
1 streaming
2 interactive
3 background
4 subscribed value. Default
This parameter indicates the maximum number of kbits/s delivered to UMTS (up-link traffic) at a SAP. As an
example a bitrate of 32kbit/s would be specified as 32 (e.g. AT+CGEQREQ=...,32,...).
0 subscribed value. Default.
1...63
64...128 (value needs to be divisible by 8 without remainder)
256
512
This parameter indicates the maximum number of kbits/s delivered by UMTS (down-link traffic) at a SAP. As an
example a bitrate of 32kbit/s would be specified as 32 (e.g. AT+CGEQREQ=...,32,...).
0 subscribed value. Default
1...63
64...256 (value needs to be divisible by 8 without remainder)
512
Multi-Tech Systems, Inc. AT Commands for EDGE Modems (S000371B) 152