AT Command Reference Guide for EDGE Wireless ... - wless.ru
AT Command Reference Guide for EDGE Wireless ... - wless.ru
AT Command Reference Guide for EDGE Wireless ... - wless.ru
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Chapter 11 – GPRS <strong>Command</strong>s<br />
11.11 <strong>AT</strong>+CGQREQ Quality of Service Profile<br />
(Requested)<br />
Description: The test command returns values supported as a compound value. If the MT supports several<br />
PDP types, the parameter value ranges <strong>for</strong> each PDP type are returned on a separate line.<br />
The read command returns the current settings <strong>for</strong> each defined context. If no requested profile<br />
was explicitly specified <strong>for</strong> a context, simply OK will be returned, but default values will be used<br />
<strong>for</strong> that context.<br />
This command allows the TE to specify a Quality of Service Profile that is used when the MT<br />
sends an Activate PDP Context Request message to the network.<br />
The set command specifies a profile <strong>for</strong> the context identified by the (local) context identification<br />
parameter, .<br />
A special <strong>for</strong>m of the set command, +CGQREQ= causes the requested profile <strong>for</strong> context<br />
number to become undefined.<br />
<strong>AT</strong>&F and <strong>AT</strong>Z will undefine the QoS profiles of every context which is not active or not online.<br />
Test <strong>Command</strong> Syntax: <strong>AT</strong>+CGQREQ=<br />
Response:<br />
+CGQREQ: , (list of supported s), (list of supported s),<br />
(list of supported s), (list of supported s), (list of supported s)<br />
OK<br />
Read <strong>Command</strong> Syntax: <strong>AT</strong>+CGQREQ<br />
Response:<br />
[+CGQREQ: , , , , , ]<br />
[+CGQREQ: ...]<br />
Write <strong>Command</strong>: <strong>AT</strong>+CGQREQ=[[, [, [, [, [, ]]]]]]<br />
Response:<br />
OK<br />
ERROR<br />
+CME ERROR<br />
Parameter Descriptions:<br />
<br />
Parameter specifies a particular PDP context definition. The parameter is local to the TE-MT interface and is<br />
used in other PDP context-related commands.<br />
1...2<br />
<br />
Precedence class<br />
0 Network subscribed value. Default.<br />
1 High Priority. Service commitments shall be maintained ahead of precedence classes 2 and 3.<br />
2 Normal priority. Service commitments shall be maintained ahead of precedence class 3.<br />
3 Low priority. Service commitments shall be maintained.<br />
<br />
Delay class<br />
This parameter defines the end-to-end transfer delay incurred in the transmission of SDUs through the GPRS<br />
network(s).<br />
0 Network subscribed value. Default.<br />
1..4 with SDU size = 128 octets and<br />
with SDU size = 1024 octets:<br />
Delay Class Mean Transfer Delay 95 percentile<br />
1 (Predictive)