MULTI TYPE

To find an indoor unit’s position from its address
▼ When checking unit numbers controlled as a group
CODE No.
SET DATA
SETTING
UNIT No.
R.C.
No.
TEMP.
ON / OFF
3
Stop
FILTER
RESET TEST
TIMER SET
TIME
SET CL
1 2
(Execute it while the units are stopped.)
The indoor unit numbers in a group are indicated one after another. The fan and louvers of the indicated units are
activated.
1
1 Push and hold the and buttons at the same time for more than 4 seconds.
• appears on UNIT No. on the LCD display.
• The fans and louvers of all the indoor units in the group are activated.
UNIT LOUVER
2 Push the button (left side of the button). Each time you push the button, the indoor unit
numbers are indicated one after another.
• The first-indicated unit number is the address of the header unit.
• Only the fan and louvers of the indicated indoor unit are activated.
3 Push the button to finish the procedure.
All the indoor units in the group stop.
▼ To check all the indoor unit addresses using an arbitrary wired remote controller.
(When communication wirings of 2 or more refrigerant lines are interconnected for central control)
CODE No.
SET DATA
SETTING
UNIT No.
R.C.
No.
TEMP.
ON / OFF
1
6
3
FILTER
RESET TEST
TIMER SET
TIME
SET CL
2
4
5
(Execute it while the units are stopped.)
You can check indoor unit addresses and positions of the indoor units in a single refrigerant line.
When an outdoor unit is selected, the indoor unit numbers of the refrigerant line of the selected unit are indicated
one after another and the fan and louvers of the indicated indoor units are activated.
132