MULTI TYPE

CODE No. list (Example)
CODE No. (DN) Item Setting data Factory-set value
01 Filter sign lighting time Depending on Type
02 Filter pollution leve 0000: standard
03 Central control address 0099: Not determined
06 Heating suction temperature shift 0002: +2°C (Floor standing type: 0)
0d Existence of automatic COOL/HEAT mode 0001: No auto mode cooling/heating * Automatically selection
0F Cooling only 0000: Heat pump
by connected outdoor
unit
10 Type Depending on model type
11 Indoor unit capacity Depending on capacity type
12 System address 0099: Not determined
13 Indoor unit address 0099: Not determined
14 Group address 0099: Not determined
19 Louver type (wind direction adjustment) Depending on Type.
1E
Temperature range of cooling/heating
0003: 3 deg (Ts ± 1.5)
automatic SW control point
28 Power failure automatic recovery 0000: None
32 Sensor SW (Selection of static pressure) 0000: Body sensor
5d High ceiling select 0000: Standard
60 Timer setting (wired remote controller) 0000: Available
F0 Swing mode 0001: Standard
F1 Louver fixing position (Flap No. 1) 0000: Not fixed (4-way type only)
F2 Louver fixing position (Flap No. 2) 0000: Not fixed (4-way type only)
F3 Louver fixing position (Flap No. 3) 0000: Not fixed (4-way type only)
F4 Louver fixing position (Flap No. 4) 0000: Not fixed (4-way type only)
Type
Code No. [10]
Setup data Type Model abb. name
0000 1-way Air Discharge Cassette MMU-APSH
0001 *1, *2 4-way Air Discharge Cassette MMU-AP2H
0002 2-way Air Discharge Cassette MMU-APWH
1-way Air Discharge Cassette MMU-APYH
0003
(Compact type)
0004 Concealed Duct Standard MMD-APBH
0005
Slim Duct
MMD-APSPH
MMD-APSH
0006 Concealed Duct High Static Pressure MMD-APH
0007 Under Ceiling MMC-APH
0008 High Wall MMK-APH
0009 — —
0010 Floor Standing Cabinet MML-APH
0011 Floor Standing Concealed MML-APBH
0012 — —
0013 Floor Standing (Below 6HP) MMF-APH
0014 Compact 4-way Air Discharge Cassette MMU-APMH
0016 Fresh air intake unit (Duct type) MMD-APHFE
Indoor unit capacity
CODE No. [11]
Setup data Model Setup data Model
0000* Invalid 0016 —
0001 007 type 0017 048 type
0002 — 0018 056 type
0003 009 type 0019 —
0004 — 0020 —
0005 012 type 0021 072 type
0006 — 0022 —
0007 015 type 0023 096 type
0008 — 0024 —
0009 018 type 0025 —
0010 — 0026 —
0011 024 type 0027 —
0012 027 type 0028 —
0013 030 type ~ —
0014 — 0034 —
0015 036 type
*1 The initial setup value of EEPROM installed on the service P.C. board
*2
For the above models, set CODE No. to “ ” and the setting data 0000 (initial) to “0001”.
282