MULTI TYPE

4 Push the TIME / buttons repeatedly to change the value indicated in the SET DATA section
to that you want.
5 Push the button.
6
UNIT LOUVER
Push the button (left side of the button) repeatedly to select another indoor UNIT No. to
change.
Repeat steps 4 to 6 to change the indoor unit addresses so as to make each of them unique.
7
UNIT LOUVER
Push the button (left side of the button) to check the changed addresses.
8 If the addresses have been changed correctly, push the button to finish the procedure.
▼ To change all the indoor unit addresses using an arbitrary wired remote controller.
(The method is available when the addresses have already been set automatically.)
(When communication wirings of 2 or more refrigerant lines are interconnected for central control)
NOTE
You can change the addresses of indoor units in each refrigerant line using an arbitrary wired remote controller.
* Enter the address check/change mode and change the addresses.
CODE No.
SET DATA
SETTING
UNIT No.
R.C.
No.
TEMP.
ON / OFF
1
3
FILTER
RESET TEST
TIMER SET
TIME
SET CL
Cancels the line selection
2
If no number appears on UNIT No., no outdoor unit exists on the line. Push
following step 2.
button and select another line
(Execute it while the units are stopped.)
1 Push and hold the TIME / buttons at the same time for more than 4 seconds.
At first, the line 1 and CODE No. (Address Change) are indicated on the LCD display.
UNIT LOUVER
SWING/FIX
2 Push (left side of the button) and buttons repeatedly to select a system address.
134