Installation and User's Guide

v SFP - The list of files protected by Windows System File Protection, and for eachfile, indicates whether that file exists. These files are backed up as part of theSYSFILES system object.v SFP= - Indicates whether the specified file (filename) is protected byWindows System File Protection. For example:SFP=C:\WINNT\SYSTEM32\MSVCRT.DLLv SYSTEMOBJECT - Windows system object information.v CLUSTER - Windows cluster information.Note: The query systeminfo command is intended primarily as an aid for IBMsupport to assist in diagnosing problems, although users who are familiar with theconcepts addressed by this information might also find it useful. If you use theconsole option, no special formatting of the output is performed to accommodatescreen height or width. Therefore, the console output might be difficult to read dueto length and line-wrapping. In this case, use the filename option with the querysysteminfo command to allow the output to be written to a file that cansubsequently be submitted to IBM support.Supported ClientsThis option is valid for all clients.Syntax►► CONsole ►◄ParametersThere are no parameters for this option.ExamplesCommand line:query systeminfo dsmoptfile errorlog -consoleRelated information“Filename” on page 381||||||||||||CreatenewbaseThe createnewbase option creates a base snapshot and uses it as a source to run afull incremental backup.Some files might not be backed up when the snapshot difference incrementalbackup command is run. If the files are skipped, you can run a snapshot differenceincremental backup with the createnewbase option to backup these files. See“Snapdiff” on page 464 for a list of reasons why a file might not be backed upwhen the snapshot difference command is run.NetApp Data ONTAP versions 8.0 and versions lower than 7.3.3 do not supportfile names that are not within the 7 bit ASCII character set. If you upgraded toNetApp Data ONTAP version 7.3.3, that supports file names with non 7 bit ASCIIcharacters, use the createnewbase=migrate option to create a new base snapshot330 IBM Tivoli Storage Manager for Windows Backup-Archive Clients: Installation and User's Guide