Volume-IF - JantERmantER

VOLUME-IF
(SER)
TENDER NO – PSER:SCT:DPL-C1154:10
TECHNICAL CONDITIONS OF CONTRACT, SCOPE ETC
(SERVICE)
PAGE 8 OF 35
13.3 The procedure for source inspection, incoming raw material inspection, verification
of material purchased etc.
13.4 Field quality plan will detail out the quality practices and procedures etc to be
followed by the contractor’s site quality control organization, during various stages
of site activities from receipt of material /equipment at site.
13.5 Bidder to arrange temperature control at around 25˚ C during chimney raft, either
by sprinkling water on course aggregate or by using Ice, including all related
arrangements for providing, storing and mixing Ice with water, cooling of
aggregates etc.
14.0 HSE REQUIREMENTS (HEALTH, SAFETY AND ENVIRONMENT)
14.1 The contractor shall ensure the safety of all workmen, materials and equipment
either belonging to him or to others working at site. He shall observe safety rules
and codes applied by the customer/ BHEL at site without exception.
14.2 Passenger lift should have safety cage with multiple rope, i.e. with safety rope &
limit switch.
14.3 Safety nets with hand railings must be provided on all both inside & outside hanging
platform of slip-form equipment & hanging platform from brickwork.
14.4 Emergency vehicle must be provided & kept separately as stand-by.
14.5 T&P used by contractor should be tested quality bearing ISI marks. Necessary test
certificates to be produced by the contractor for all the T&P received by him at site
for acceptance by BHEL Engineer. BHEL will reject any T&P without IS test
certificate and the same cannot be utilized on job.
14.6 Only trained and experienced personnel to be used on the job. Signalling for rigging
operations must be given by workers who are possessing required skill and
experience in handling materials.
14.7 Non-conformity of safety rules and safety appliances will be viewed seriously and
BHEL has right to impose fines on the contractor on each incident/each nonconformity
as per details given below.
Safety measure
Fine (Rs)
14.7.1 Not wearing safety helmet & safety shoe. Will not be permitted to
enter the plant
14.7.2 Not wearing safety belt. Will not be permitted to
work at heights for erection
job.
14.7.3 Grinding without goggles. 25/workmen
14.7.4 Not using 24V supply for internal work. 500/case
14.7.5 Electrical plugs not used for hand machines. 100/case
14.7.6 Welding cables, electrical wires not insulated with 50/joint
proper/ standard.
14.7.7 Not removing scrap from platform. Actual cost for removal plus
30 %
14.7.8 Gas cutting without taking proper precaution/not 100/case
using sheet below per incidence.
14.7.9 Electrical winches having no guards earthed properly 500/case
etc.
14.7.10 Improper earthing of electrical T&P. 200/ equipment
14.7.11 Not protecting/locating the gas cylinder to avoid 100/cylinder
catching of fire.
14.7.12 Not providing earth leakage circuit breaker as per 1500/point
direction of BHEL.
14.7.13 Not slinging properly 200/case
14.7.14 Using damaged sling 200/case
14.7.15 Lifting cylinders without cage 500/case
14.7.16 Backfire arrestor 500/case
14.7.17 Life line 500/case
14.7.18 Fall arrestor 500/case