Volume-IF - JantERmantER

DCPL-K9AOl
iii) Fabricated sandwich melal cladding. Sample size shall be 300
x 300 mm three nos.
iv)
Edge r;eaJing and flashing.
b) Manufacture~s literature indicating the nature of preformed profiled,
colour coating. manufacturer's recommended Installation, Instructions
and maintenanca procedure.
c) Manufacturer's certifICation of compliance with each delivery.
d) Shop Drawings
Showing fabrication details of sandwich/double skin metal cladding
with Insulation, preformed sheet profde and total colour thickness for
profiled top skin and slighlly ribbed bottom skin. thickness and nature
of insulation. inslallationand erection; anchorage. fasteners and
details of acoassories. metal flashing and its fixing including various
openings for doors. windows,louvres, pipes etc,
•
1.03.02
Test Reports
Two copies ofTest Reports and Souroa of Quafity Control Tests.
1.03.03
Supplier Ceitlftcates
Two copies of tedlnic:al data showing that the proposed finish product is
suitabre for the environmental conditions ofthe job site and that the materials
meet specific:ation requirements.
1.04.00
1.04.01
Product Handling
Delivery of Materials to Job site In manufactur~s
packaging .
original unopened
1.04.Q2
1.04.03
. Identify contents with /lame of,mimufacturer. brand name, thermal value and
.appllaitile siandllt'd. .
" ., .....
Store materials In an area protected from adverse ctimStic conditions.
,moisture and open flame or spark and shall be stored off the ground with one
end elevated for drainage. The sheets shall be protected from inclement
weather with a waterproof covering with ventilation to avoid condensation.
2.00.00
2.01.00
Ull.01
PRODUCTS
General
All goods and products covered by these specifications shall be procured
from manufacturer duly approved by the owner
(PCA,CI).OO3.S805CSA19.docl V.tI-02IS-XIX : 2
.' .
270