Volume-IF - JantERmantER

4.0.0 INFORMATION TO BE SUBMITTED
DCPL-K4A02
4.1.0 With Tender
a) Names of manufacturers for doors, windows, etc.
b) Manufacturer’s catalogue for all hardware and fixtures proposed to be used.
4.2.0 After Award
a) Before starting fabrication of all metal doors, windows, etc. the Contractor shall
submit detailed fabrication drawings to the Engineer for approval. The
fabrication shall be started only after approval of drawings.
b) He shall submit a programme of work to be done for the approval of the
Engineer.
c) Before bulk supply, he shall submit for the approval of the Engineer samples of
all bought out items and samples of each type of fabricated items. The samples
shall be retained by the Engineer for comparison of bulk supply and returned to
the Contractor towards the end for final incorporation in the job.
5.0.0 RATES
[This clause may be ignored in view of EPC mode of execution]
Rates shall be unit rates for items described in the schedule.
6.0.0 METHOD OF MEASUREMENT
[This clause may be ignored in view of EPC mode of execution]
a) Supply and installation of doors shall be measured in number of each type used.
The types shall be as shown on drawings and described in Schedule of Items.
b) Supply of windows shall be measured in number of each type of unit used either
single or in combination.
c) Installation including assembly and erection of windows shall be measured in
number of types of combinations mentioned in the Schedule of Items.
d) Supply and installation of louvers shall be measured for area of opening in which
the louvre is to be installed.
e) Supply of mullions and transoms shall be measured for net length of different
types shown on drawings and described in Schedule. In computing the length, the
length required for embedding in concrete or masonry shall not be considered. No
extra payment shall be made for end or cover plates.
f) Vision panels, louvers to doors and insulation between door faces shall be
measured for actual area and paid separately over the basic rate doors.
(PCA.775.S034sc14) V.II-D2/S-XIV : 9