Volume-IF - JantERmantER

TITLE:
SPECIFICATION NO. PE-TS-360-620-C001
VOLUME - II B
SPECIFIC TECHNICAL
REQUIREMENTS FOR
SECTION - C SUB SECTION: II
ELECTRICAL WORKS
SHEET 5 OF 6
with cable boxes, double compression nickel-chromium plated brass cable
glands (heavy duty type), solderless tinned copper crimping cable lugs etc.
2.14 The size of two nos. down conductors for earthing are 50 x 6 mm GS flat
extending at different platforms for electrical equipment earthing. These
down conductor are in addition to lightning down conductor.Total four nos.
down conductor shall be provided
2.15 Various drawings, data, calculations, test reports, test certificates, operation
and maintenance manuals etc. as specified shall be furnished after award of
contract for approval of purchaser/customer/consultant.
2.16 Make of equipment/components shall be subject to
purchaser/customer/consultant approval after award of contract without any
commercial or delivery implications to the purchaser.
2.17 Bidder shall quote for mandatory spares for electrical equipment as per
attached list. Bidder may further note that purchaser reserves the right to
delete any item/ all items from the list after award of contract.
2.18 Bidder shall furnish list of recommended spares for 3 years for all electrical
equipments with unit prices.
2.19 Start-up & commissioning spares for electrical equipment shall be supplied
on as required basis and cost for the same shall be included in the main
equipment cost.
2.20 Bidder shall furnish List of Erection & maintenance tools & tackles with the
offer.
2.21 Bidder shall furnish unpriced “Price Schedule” for electrical equipments with
the offer.
2.22 All equipment shall be suitable for the power supply fault levels and other
climatic conditions mentioned in the enclosed project electrical information.
2.23 Bidder shall furnish electrical load requirements for normal 415V AC &
Emergency 415V AC after award of contract.
2.24 The final technical particulars of various electrical equipment/ components/
items shall be subject to purchaser/consultant/customer approval after award
of contract.
2.25 The detailed Schedule of Equipment is enclosed in the form of Electrical
Equipments BOQ.
2.26 Various drawings/ documents for electrical equipments for chimney shall be
prepared by bidder after award of contract for approval of
purchaser/customer/consultant.
REV.NO. 0 DATE: 18.09.2010
3.00 EQUIPMENT & SERVICES TO BE PROVIDED BY PURCHASER FOR
ELECTRICAL & TERMINAL POINTS
3.01 Power cables for incomer to 415 V AC Distribution Board (ACDB) and AC
Emergency Lighting distribution board (ELDB). However, termination of
incomer power cables in ACDB & ELDB shall be carried out by bidder.
ACDB & ELDB shall be located inside the chimney. Bidder to note that the
second incomer to ELDB shall be derived from ACDB by the bidder. Cable
glands and lugs shall be supplied by the bidder.
3.02 Cable trench, cable trays/GI pipes up to the boundary limit of the chimney
i.e. 3M away from outer shell. Bidder shall coordinate with the purchaser for