Volume-IF - JantERmantER

DCPL-K4A02
Materials or workmanship not in reasonable conformance with the
provisions of this Specification may be rejected at any time during the
progress of the work.
The quality control procedure shall cover but not be limited to the following
items of work :
1) Steel : Quality, manufacturer's test certificates, test reports
of representative samples of materials from
unidentified stocks if permitted to be used.
2) Bolts, Nuts : Manufacturer's certificate, dimension
& Washers checks, material testing.
3) Electrodes : Manufacturer's certificate, thickness and quality of flux
coating.
4) Welders : Qualifying Tests
5) Welding sets : Performance Tests
6) Welds : Inspection, X-ray, Ultrasonic tests
7) Paints : Manufacturer's certificate, physical inspection reports
8) Galvanizing : Tests in accordance with IS : 2633 -
Method for testing uniformity of coating on Zinc
Coated Articles and IS : 4759 - Specification for Hot-
Dip Zinc coatings on Structural Steel and other
allied products.
2.8.0 Standard dimensions, forms and weights
The dimensions, forms, weights and tolerances of all rolled shapes bolts,
nuts, studs, washers etc. and other members used in the fabrication of
any structure shall, wherever applicable, conform to the requirements of
the latest relevant Indian Standards, wherever they exist, or, in the absence
of Indian Standards, to other equivalent standards.
2.9.0 Shop Drawings
The Contractor shall submit to the Engineer the Schedule of Fabrication
and delivery of structural steelwork for approval. He shall start to submit
progressively for approval the shop drawings based on the approved Design
Drawings and before proceeding with the fabrication work, shall get the
said shop drawings approved in accordance with the contract.
(PCA.774.S034sca4) V.II-D2/S-IV : 9