Volume-IF - JantERmantER

DCPL-K4A02
Unless specified otherwise, inspection to all work shall be made by the
Engineer or Engineer's representative at the place of manufacture prior to
delivery. The Engineer or his representative shall have free access at all
reasonable times to those parts of the manufacturer's works which are
concerned with the fabrication of the steelwork under this Contract and he
shall be afforded all reasonable facilities for satisfying himself that the
fabrication is being done in accordance with the provisions of this
Specification.
The Contractor shall provide such labour, materials, electricity, fuel, water,
stores, tools and plant, apparatus and instruments as may be required by
the Engineer to carry out inspection and/or tests in accordance with the
Contract.
The Contractor shall guarantee compliance with the
Specification.
provisions of this
4.2.0 Testing and Acceptance Criteria
4.2.1 General
4.2.2 Steel
The Contractor shall carry out sampling and testing in accordance with
the relevant Indian Standards and as supplemented herein for the
following items at his own cost, unless otherwise specified in the Contract.
The Contractor shall get the specimens tested in a laboratory approved by
the Engineer and submit to the Engineer the test results in triplicate
within 3 (three) days after completion of the test.
All steel supplied by the Contractor shall conform to the relevant Indian
Standards. Except otherwise mentioned in the Contract, only tested quality
steel having mill test reports shall be used. In case unidentified steel
materials are permitted to be used by the Engineer, random samples of
materials will be taken from each unidentified lot of 50 M.T. or less of any
particular section for tests to conform to relevant Indian Standards.
All material shall be free from all imperfections, mill scales, slag intrusions,
laminations, pittings, rusts etc. that may impair their strength, durability and
appearance.
4.2.3 Testing Criteria for checking Lamination in raw steel plates
All raw steel plate of thickness more than 20 mm supplied by the
contractor shall be checked against lamination before procurement & prior
(PCA.774.S034sca4) V.II-D2/S-IV : 19