Volume-IF - JantERmantER

TITLE:
LIGHTING DISTRIBUTION BOARD
& LIGHTING PANEL
SPECIFICATION NO. PES-558-01A
VOLUME - II B
SECTION - D
REV.NO. 0 DATE
SHEET 1
OF
4.6.5 Internal power wiring shall be done with PVC insulated Cu wire of suitable size. All
control wiring inside the panel shall be carried out with 1100 V grade, PVC insulated
flexible copper wires.
5.0 Guaranteed Performance Requirements
5.1 The vendor shall guarantee satisfactory performance of the equipment under all
conditions and requirement as laid down by this specification.
5.2 For the general requirements of performance guarantees refer to other parts of the
specification.
6.0 PAINTING
7.0 TESTS
(All metal surface shall be cleaned, phosphated and given two coats of rust-resistant
primer followed by two coats of synthetic enamel paint in light grey shade (IS:5 shade
631).
Each panel shall be completely assembled, wired, adjusted and tested at the factory
prior to shipment. The test shall include wiring continuity tests, insulation tests and
functional tests to ensure satisfactory operation and control of individual equipment.