Volume-IF - JantERmantER

VOLUME-IF
(SER)
TENDER NO – PSER:SCT:DPL-C1154:10
TECHNICAL CONDITIONS OF CONTRACT, SCOPE ETC
(SERVICE)
PAGE 14 OF 35
details of the numbers and trades of workmen whom the contractor proposes to
employ (whether directly or through sub-contractors) on the site throughout the
periods shown in the Project Schedule. Such details shall be in the form of a
periodic histogram, accumulative `S’ curve and summary line item tabulation or
such other form as customer may reasonably request and the contractor normally
utilizes.
16.6.2 As far as practicable, the Contractor shall give preference in the employment of
unskilled labourers at the Site to persons living locally in consultation with
customer’s IR Department.
16.7 Quality Assurance
16.7.1 All materials, components and equipments covered under the specification shall be
procured, manufactured, erected, commissioned and tested, as applicable, at all
stages as per comprehensive quality assurance program. An indicative program for
inspection/ test, to be carried out by the contractor, for some of the major items is
given in the respective technical specification.
16.7.2 Approved Field quality plan of BHEL/ customer will detail out the quality practices
and procedures etc to be followed by the contractor’s site quality control
organization, during various stages of site activities from receipt of material/
equipment at site.
16.7.3 Casting and forgings used for construction shall be of tested quality. Details of
results of chemical analysis, mechanical properties test result, as necessary, shall
be furnished.
16.7.4 All welding shall be carried out as per procedure drawn and qualified in accordance
with the requirements of ASME Section-1X/ BS4870 or other international
equivalent standard acceptable to BHEL/ customer.
16.7.5 All welders etc employed on any part of the contract at contractors’ work or at site
shall be qualified as per ASME Section-IX or BS 4871 or equivalent international
standard approved by BHEL/ customer. Such qualification test shall be conducted
in presence of BHEL/ customer.
16.7.6 All non-destructive examinations (NDT) shall be carried out in accordance with
approved international standard. NDT operators shall be qualified as per SNT-TC-
IA (of American society of non-destructive examination) Results of NDT shall be
properly recorded and submitted for approval.
16.7.7 All the purchase specifications for the major bought out items list of which shall be
drawn up by the contractor and finalized with BHEL/ customer shall be furnished to
BHEL for comments and approval before placement of orders.
16.7.8 BHEL/ customer reserves the right to carry out quality audit and quality surveillance
of the systems and procedures of contractor’s quality management. Contractor
shall provide all necessary assistance to enable BHEL/ customer to carry out such
audit.
16.7.9 Quality audit/approval of the results of test and inspection will not prejudice the right
of BHEL/ customer to reject an equipment service not giving the desired
performance and shall not in no way limit the liabilities and responsibilities of the
contractor in earning satisfactory performances of equipment/service as per
specification.
16.7.10 Repair/ rectification procedure to be adopted to make any job acceptable shall be
subject to the approval of BHEL/ customer.
16.7.11 All the latest relevant IS codes as per technical specification & requirement should
be available with contractor at site within 45 days from the date of LOI.
17.0 GENERAL GUIDELINES FOR FIELD ACTIVITIES
17.1 The contractor shall execute the works in a professional manner so as to achieve
the target schedule without any sacrifice on quality and maintaining highest
standards of safety and cleanliness.
17.2 The contractor shall co-operate with owner/ BHEL and other contractors working in
site and arrange to perform his work in a manner so as to minimise interference
with other contractor’s works. BHEL's engineer shall be notified promptly of any