Genesys User Manual - AMS Neve

Settings
Contains system-wide parameters regarding:
• 8T to Loudspeaker routing
• Solo linking
• Power Up status and TB Functions
• Path calibration (Level Settings)
• Loudspeaker settings
• Console Utilities
LS Settings
All of the settings below can also be set in SEL Mon Mode using the
Monitor Panel.
8T To Mon
This matrix allows any of the 8T to be fed to any of the speakers.
There are no limits as to which 8Ts feed which speakers.
▶ Click in the junction of the speaker and the 8T to make or break the
route.
A will be placed on screen at the appropriate junction on screen when a
route has been created.
Sub To DownMix
The Down-mix is when a Surround Mix is collapsed down to either Stereo
or Mono.
Ticking this option includes the Sub feed when the mix is collapsed to
stereo, otherwise it will be not be included.
5.1 Mono
Allows the collapse of a 5.1 Surround mix down to Mono.
LS SOLO
Sets the L, C, R, LS, S and RS speaker buttons to act as a SOLO, rather
than as a CUT.
The LS SOLO led above the speaker buttons will light when selected.
SUB
Applies a fixed Lo-pass filter (at 82Hz) to the Sub speaker for checking
purposes.
Down Mix To
When a Surround mix is collapsed down to Stereo, this down-mix can also
be tied to a set of loudspeakers.
If the Down Mix is tied to the M1 speaker set, then selecting M1 will also
operate the stereo downmix via the ST button.
Sub Speaker Locks
Locks the house sub on the A set of loudspeakers to B ,M1, M2
loudspeaker sets.
LS/RS Speaker Locks
Locks the house LS/RS on the A set of loudspeakers to B ,M1, M2
loudspeaker sets.
- 104 -