You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Windows 7 Drivers<br />
This section only applies if you have Windows 7 as the operating system<br />
on your DAW, and explains how to swap between the standard FireWire<br />
driver, and the Legacy FireWire driver.<br />
As new drivers and console software builds are released using the legacy<br />
driver may not be applicable in future releases, the <strong>Genesys</strong> software<br />
release notes will detail this if it is the case which can be accessed from<br />
System > Release Notes. You can swap between legacy and standard<br />
FireWire driver as shown below at any time.<br />
Using the Legacy Driver<br />
▶ With the FireWire cable disconnected from the <strong>Genesys</strong> computer, go to<br />
Start Menu / Control Panel / System and in the Device Manager, find<br />
the FireWire device (IEEE 1394).<br />
▶ Right-click it and select Update Driver Software...<br />
▶ Select Browse my computer for driver software<br />
▶ Select Let me pick from a list of device drivers on my computer<br />
▶ Install the driver that ends with 1394 OHCI Legacy.<br />
▶ Click OK to install the driver.<br />
▶ Reinstall the <strong>Genesys</strong> driver, as shown on page 134.<br />
If you are using <strong>Genesys</strong> software V3.3 build 1 or later, then you will need<br />
to update the FireWire driver.<br />
This driver is available from our website, for either Mac or PC:<br />
http://www.ams-neve.com/Products/Music/<strong>Genesys</strong>/<strong>Genesys</strong>.aspx<br />
Download this driver relevant to your DAW Mac or PC, then run and install<br />
it.<br />
PC:<br />
You can check it has been installed by going to All Programs / <strong>AMS</strong> <strong>Neve</strong><br />
Ltd / <strong>Neve</strong> FireWire Card.<br />
▶ Click OK on the small information screen that opens<br />
- 155 -
Change language