Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
This control also globally swaps the Large Fader & Cut with the Small<br />
Fader & Cut within the Channel and Monitor paths.<br />
MIX<br />
Puts the console into Mix-down mode and cancels the Mic/LN inputs to<br />
clearly indicate Mixdown Mode.<br />
It will change the audio feeds to the Channel and Monitor auxes from Precut<br />
(Pre-fade), to Post-cut (Pre-fade) within the channel.<br />
This will allow the Pre-Fade Auxes to be Pre-Cut for recording, but Post-<br />
Cut for mixing.<br />
It will also set the Master CH DAW, I/P 2 and the Mon DAW RET to be<br />
On, and will also turn DAW Channel, IP2 and DAW RET to be on locally<br />
on each channel, enabling both the channel path and the monitor path to<br />
return for mixing.<br />
CH SAFE<br />
Lights yellow and stops the channel SOLO buttons from affecting the<br />
channel Solo Cuts when selected.<br />
It also causes the AFL/PFL led to flash and the AFL to switch into the LS<br />
monitor path if a Channel SOLO is selected.<br />
It will also allow SIF and PFL in the Monitor Section to be selected.<br />
It will also turn SOLO LINK off if selected.<br />
(If CH SAFE is not selected, then the Solo system will be destructive).<br />
In this mode, all channel CUTS will be deactivated if a channel solo is<br />
selected.<br />
MON SAFE<br />
Lights yellow and stops the Monitor SOLO buttons from affecting the<br />
Monitor Cuts.<br />
It will enable the AFL/PFL led on the Monitor Panel to flash and the AFL<br />
to be switched into the LS Monitor path if Mon Solo is selected.<br />
It will also allow SIF and PFL in the monitor section to be selected.<br />
Lastly, it will turn SOLO LINK off if selected.<br />
In this mode, all monitor CUTS will be deactivated if a monitor Solo is<br />
selected.<br />
8T SAFE<br />
It is also possible to make the 8T Solo system safe by selecting SAFE in<br />
the Settings screen.<br />
This will then enable the AFL/PFL led on the Monitor panel to flash and<br />
the AFL to be switched into the LS Monitor path if any 8T Solo is selected.<br />
It will also allow SIF and PFL into the Monitor section to be selected.<br />
However, it will not cancel Solo Link.<br />
I/L<br />
Makes the Monitor, Channel & 8T SOLO buttons interlock within their<br />
systems.<br />
- 64 -
Change language