Genesys User Manual - AMS Neve

plug-in on/off by rotating the Ch V-Pot.
▶ By pressing F3 and F4 button you can go up down the parameter
pages.
▶ Change the parameter values by rotating the Ch V-Pots.
▶ The Genesys software track information text shows the parameter
information and page information.
▶ In a similar way you can choose an insert slot, change the plug-in
selection, and edit the parameters for all other DAW tracks.
▶ Press F5 and FLIP should now be on. With FLIP on the Genesys faders
will now have the functionality of the Ch V-Pots (the DAW faders will now
be controlled by the Ch V-Pots).
FADS and BANKS
FADS allows a large session with lots of tracks to be seamlessly controlled
from Genesys.
▶ Press FADS (the button will light).
▶ Use the ◀ & ▶ buttons to move the DAW tracks up/down the console
surface a single track at a time.
▶ If the BANKS button is lit, using the ◀ & ▶ buttons will move the DAW
tracks up/down the console surface eight tracks at a time.
The tracks currently under control will be displayed on screen.
AUTO
AUTO allows the Automation Modes to be changed on any of the DAW
tracks by using the fader SEL buttons.
▶ Press the AUTO button
▶ Now press the fader SEL button on the console to change the
automation mode.
▶ Pressing the fader SEL button repeated will cycle through the
automation modes in your DAW for that track.
Turn off AUTO when not in use as the fader SEL buttons are used to
control these functions and you may inadvertently change something.
CHAN
CHAN puts the DAW tracks into Track Arm (Record Enable) mode and
tracks can be armed on/off by using the fader SEL buttons.
▶ Press the CHAN button
▶ Now press the fader SEL button on the console to put the track into
armed mode/record enabled.
▶ Pressing the fader SEL button repeated will toggle (on/off) the track
arm/record enable mode in your DAW for that track.
Turn off CHAN when not in use as the fader SEL buttons are used to
control these functions and you may inadvertently change something.
- 190 -