Genesys User Manual - AMS Neve

Connectors & switches
25-way D-type connectors
There are two 25-way D-type connectors on both the Master and Slave
FireWire cards.
These connectors use standard Tascam AES wiring protocol.
On a Master AD/DA card, from left to right, these D-type connectors are
labelled as follows:
1. AES RX DLINE / AES TX
2. AES RX DMON / AES Sync In/Out
Each 25-way connector carries (up to) 8 pairs signals, and these are as
follows:
AES RX DLINE / AES TX
Connector
number
Signal name
(system name)
Pin
Shield Hi Low
1 AES RX 1 (DLINE 1 & 2) 25 24 12
2 AES RX 2 (DLINE 3 & 4) 11 10 23
3 AES RX 3 (DLINE 5 & 6) 22 21 9
4 AES RX 4 (DLINE 7 & 8) 8 7 20
5 AES TX 1 (Direct Output 1 & 2) 19 18 6
6 AES TX 2 ( Direct Output 3 & 4 ) 5 4 17
7 AES TX 3 ( Direct Output 5 & 6) 16 15 3
8 AES TX 4 ( Direct Output 7 & 8) 2 1 14
AES RX DMON / AES SYNC IN/OUT
Connector
number
Signal name
Pin
Shield Hi Low
1 AES RX 1 (DMON 1 & 2) 25 24 12
2 AES RX 2 (DMON 3 & 4) 11 10 23
3 AES RX 3 (DMON 5 & 6) 22 21 9
4 AES RX 4 (DMON 7 & 8) 8 7 20
5 - - - -
6 - - - -
7 AES Sync Out * 16 15 3
8 AES Sync In * 2 1 14
* These are AES Sync I/O connections only, not audio paths.
Channel Slave Audio Link
These should only ever be connected to the corresponding port of the
same name on the associated Slave card, 1 to 1, 2 to 2 and 3 to 3.
Please see section on Cabling starting on page 140.
- 126 -