Genesys User Manual - AMS Neve

NB:
This feature requires supporting hardware, so will not available on all
consoles.
▶ Before accessing these extra monitoring inputs, please ensure the EXT
button is lit on the Monitoring panel.
▶ These extra externals are accessed by pressing the RTE SEL button
(this will open the standard routing screen), and then pressing both of the
arrow buttons underneath together.
This will open the Externals screen.
The ◀ and ▶ buttons on the ROUTE SEL section of the Monitor Panel set
the function of the 1-8 routing buttons, either setting their function to
Externals 5-12 (◀ button lit) or 13-20 (▶ button lit).
A yellow highlight bar will appear around the block of externals that are
currently assigned to buttons 1-8.
The 1-8 routing buttons will now turn the corresponding external in that
block on or off:
▶ Button 1 will turn Ext 5 or Ext 13 on or off;
▶ Button 2 will turn Ext 6 or Ext 14 on or off, etc.
If the SUM button is not pressed, the selection of Externals will be
interlocked.
If the SUM button is pressed, it will be possible to listen to more than one
External at a time. In this case, there is no limit to the number of
externals that can be monitored at any one time.
To exit this mode, press both of the ◀ and ▶ buttons again, then press
RTE SEL.
D-EXT led
▶ The D-EXT led will light on the second press of EXT 2.
It is possible to have two sets of six-wide Externals on EXT 2.
The second set can be selected by pressing the EXT 2 button again.
▶ 1st press takes the 1st set of External feeds from the Analogue inputs
(EXT 2 will light)
▶ 2nd press takes the 2nd set of External feeds from the Digital Inputs (if
these are present, EXT 2 and the D-EXT led will light)
The D-EXT led will only light if an AD/DA cassette has been detected.
If there is no cassette, it will not be possible to select D-EXT.
INT
▶ Lights yellow when selected and makes possible the selection of the
internal monitors (Auxes, Cues etc) to the control room loudspeakers.
- 74 -