Genesys User Manual - AMS Neve

The level has a range of -∞ to 0dB.
▶ Press to operate, the yellow led underneath will light and Talkback will
be sent to TB Output.
This will also dim the monitoring by an amount set by TB DIM (and light
the DIM button).
If RTB is on M2, then applying TB will temporarily suspend the Return
Talkback.
TB ALL
This momentary push switch can be used to send Talkback to CUE1,
CUE2 & TB out destinations.
The led lights yellow for the length of the press, and the talkback will be
sent to all available destinations.
This action will also light the DIM button, and dim the monitoring by an
amount set by TB DIM.
If RTB is on M2, then Operating all will temporarily suspend the Return
Talkback.
RED LIGHT
Lights red and allows for a studio 'recording light' to be switched on and
off from the console surface, or remotely via the DC REMOTE connector
on the rear of the console.
Spare Button
Located next to the TB ALL control, this control is software mapped to
control the 'Spare I/O Pin' on the DC remote connector allowing for a
switched output. Useful for control of external TB systems.
Talkback Enable (Located in the Settings screen)
This control if ticked will allow CUE1 and CUE2 to turn on the TB Relay
allowing for an extra TB level control output to be sent to the studio TB
system.
Talkback Latch (Located in the Settings screen)
Interlocked with Auto TB. If ticked will turn CUE1 and CUE 2 from
momentary to latching, even if Play is being cycled on the DAW.
NB:
Remote operation of the CUES will also be changed from
momentary to latching in TB Latch mode.
- 84 -