Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Apple Logic Pro<br />
Before using the <strong>Genesys</strong> with an Apple Logic Pro system, please ensure<br />
that both systems are properly configured as outlined on page 25.<br />
This involves:<br />
• Setting the IP addresses on <strong>Genesys</strong> and the DAW computer.<br />
• Connecting the network ethernet cabling.<br />
• Installing the ipMIDI driver.<br />
<strong>Genesys</strong> Setup<br />
▶ Go to Settings / Services and make sure Apple Logic Pro is selected<br />
at the top of the screen.<br />
▶ For #1, select the MIDI Port, then the console 8 block of faders on<br />
which you wish these DAW tracks to appear.<br />
NB:<br />
The 8T faders are referred to in the pull-down list of options as Master.<br />
▶ Repeat for all the other available MIDI Ports and fader blocks on the<br />
console.<br />
NB:<br />
This mapping must match that set in Logic Pro. The same MIDI Port<br />
cannot be used more than once (including the one set for Midi Timecode).<br />
The 8 block of faders can only be linked to a single MIDI Port and not<br />
repeated.<br />
The DAW control is limited to controlling a maximum of 48 Logic tracks or<br />
6 MIDI Ports (this does not include the MIDI Port used for MTC).<br />
▶ Once set, click OK. Follow the on-screen instructions to re-launch the<br />
software to apply the new changes.<br />
Apple Logic Pro Setup<br />
▶ On the Logic DAW, from the menu bar at the top of the screen click<br />
Logic Pro / Preferences / Control Surfaces / Setup.<br />
▶ At the top of the screen, select New / Install.<br />
You will be presented with a list of possible DAW Master Controllers.<br />
▶ Select the Mackie Designs – Mackie Control – Logic Control entry<br />
and click Add.<br />
▶ Once added, click on the Mackie Control icon, and at the top of the left<br />
hand pane, set the Input and Out Port port to Port 1 (or whatever was<br />
set in the <strong>Genesys</strong> software for the first block of 8 tracks).<br />
The Input / Out Port port parameters for the DAW Master Controller and<br />
each DAW Extender Controller must match port-for-port with that set in<br />
the <strong>Genesys</strong> software.<br />
▶ On the Logic DAW, from the menu bar at the top of the screen again<br />
click Logic Pro / Preferences / Control Surfaces / Setup.<br />
▶ At the top of the screen, select New / Install.<br />
▶ This time select Mackie Designs - Mackie Control Extender - Logic<br />
- 174 -
Change language