Genesys User Manual - AMS Neve

EXT
▶ Will light yellow when selected, and makes possible the selection of the
External monitors (EXT 1 etc) to the control room loudspeakers.
INT and EXT are interlocked.
If SUM is selected, the interlock between INT and EXT is cancelled.
SUM
▶ Lights yellow when selected and affects the INT and EXT as described
above, so a collection of Internal and External sources can be heard at
once.
It will also enable all of the internal and external LS buttons (including
INT and EXT monitor selections) to be turned on and off individually.
In this mode, 8T and 2T on the internal monitor will still be interlocked.
INS
Lights yellow and activates the 5.1 Monitor inserts.
ST (or DownMix)
Collapses the 5.1 monitor mix into stereo by sending the Surround paths
to form a Stereo mix:
Surround signal
Left
Right
Centre
Sub
Left Surround
Right Surround
Stereo downmix
Left
Right
Left & Right
Left & Right
Left
Right
It is also possible to tie a particular set of loudspeakers to the stereo
DownMix, so that selecting the particular speaker set, will also select that
DownMix to monitor.
See section below on Master SEL Mode.
NB:
It is possible to alter the level contribution to the Centre, Sub, Left
Surround & Right Surround by adjusting the factory set preset pots on the
rear of the LS M1 Output cassette.
ØL
Inverts the phase of the Left side of the monitoring.
AFL/PFL led
This yellow led flashes if a Channel SOLO (with CH SAFE selected), or a
Monitor SOLO (with MON SAFE selected) is pressed.
It will also light if the 8T SOLO is made safe via the Settings screen, or if
any of the AFL buttons on the Rev Returns are selected. Indicates that the
AFL is the solo source fed to the monitor loudspeakers.
- 75 -