Genesys User Manual - AMS Neve

The speaker button will light when selected to confirm the route.
▶ Rotate the monitoring knob to select the next 8T to configure and
repeat until all the 8Ts are mapped.
▶ You will notice that the LS setups have been ticked in the LS matrix
boxes to configure the route in the settings screen. It is also possible to
just tick the boxes using the console mouse to achieve the desired routing
as well.
▶ Press the RTE SEL button on the Route SEL panel to exit Master SEL
mode to lock these routes into place.
The console LS source is now configured to work in Surround.
If you now wish to create a Down Mix of the Surround Mix simultaneously,
this can be achieved by using the 2T mixer which is described later in this
manual.
Shown here is the signal path through the console when set to work in 5.1
Surround using Stereo Pans:
NB:
The same block can be used for the LCR surround panning but the
C buss is fed with the C part of the LCR pan, not Aux 1 (8T7) as in
the Stereo Pan surround setup.
- 43 -