Genesys User Manual - AMS Neve

Mixer View allows you to edit a single Send parameter on multiple
channel strips laid out across the Genesys console surface: Send
Destination, Send Level, Send Position (Pre/Post/Post Pan), Send Mute.
The Genesys software (at the top) will indicate the function or mode you
are in along with the current Send, [S1], [S2]... [S8]. DAW control
allows you to control up to 8 Logic Sends per track.
▶ Press the fader SEL button for Logic track 1 (or the first assigned DAW
track). You have now selected DAW track 1. You will see in the top right
corner the display indicator has changed to 01 (if not already) to indicate
you have selected track 1. The fader SEL button will also flash.
▶ F1 and F2 buttons are used to select which Send you are controlling.
Now keep pressing F1 until you are see that you are controlling Send 1,
[S1] will be shown on the Genesys software.
▶ F3 and F4 buttons are used to select the Send
Destination/Level/Position/Mute parameter. Now keep pressing F3 until
you are are controlling the Send Destination parameter. This will be
shown on the Genesys software on the top-most line.
The Genesys software should now show the following information on the
top-most line:
Send Mixer View – Send Parameter: Destination [S1]
▶ On the channel strip using the Ch V-Pot (large red encoder) for the
selected track turn the encoder and the Destination will change, Bus 1,
Bus 2... Bus 64. This will be shown on the Genesys software as you
change the parameter.
▶ Press the Ch V-Pot (like you would do to a push-button) and the
Destination will be set. Confirm this by looking at Logic Pro for track 1,
send slot 1.
▶ In a similar way you can change the Destination for all other DAW
tracks.
▶ Press F4. You are now controlling the Send Level for Send 1. Turn the
Ch V-Pot and the Send Level will change, you can see the Genesys
software and Logic Pro to verify this.
▶ Pressing the Ch V-Pot you can set the Send Level to its default setting.
Press the Ch V-Pot, the Send Level will default to 0 dB. Confirm this by
looking at Logic Pro for track 1, send slot 1.
▶ In a similar way you can change the Send Level for all other DAW
tracks.
▶ Press F4. You are now controlling the Send Position for Send 1. Turn
the Ch V-Pot slowly one click/notch at a time up to a maximum of 2-left or
2-right and the Send Position will change from Pre to Post to Post Pan.
You can see the Genesys software and Logic Pro to verify this.
▶ In a similar way you can change the Send Position for all other DAW
tracks.
▶ Press F4. You are now controlling the Send Mute for Send 1. Press
the Ch V-Pot and the Send Mute will change from Mute to Active. You
can see the Genesys software and Logic Pro to verify this.
▶ In a similar way you can change the Send Mute for all other DAW
tracks.
▶ Press F5 and FLIP should now be on. With FLIP on the Genesys faders
will now have the same functionality as the Ch V-Pots. Press F3 until you
are once again controlling the Send Level. Now with FLIP on move the
Genesys fader for DAW track 1. The Send Level will change, confirm this
- 178 -