Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Installation of cards<br />
Master or Slave cards<br />
The installation for the Master and Slave cards is identical.<br />
Ensure the power is removed from the console, observing the correct<br />
Shutdown procedure.<br />
Unscrew the two outer screws that hold the faceplate to the console<br />
chassis, labelled 'A' below.<br />
Please be aware that if the optional Dynamics card is fitted, this card will<br />
be attached to the faceplate when it is removed.<br />
▶ Unscrew the blanking plate that is fitted to the lower half of the plate,<br />
removing the two screws labelled 'B' above.<br />
▶ Insert the AD/DA card into the lowest slot in the available space in the<br />
console, (with the components facing down), ensuring that the card's<br />
rear-edge connector makes a firm contact with the connector on the<br />
console backplane.<br />
▶ Screw the faceplate back to the console chassis (using the 'A' screws),<br />
making sure that all the connectors on the AD/DA card (BNC, FireWire, D-<br />
subs etc) clear the faceplate.<br />
▶ Screw the four jack-posts either side of the D-sub connectors, plus the<br />
two nuts & washers over the BNC connectors into place.<br />
There is a small double-ended spanner included with the kit of parts for<br />
this purpose.<br />
On consoles with a different Channels faceplate (manufactured before May<br />
2010), you will also be sent a new faceplate with the AD/DA card.<br />
If applicable, this should have the Dynamics cassette fitted to it before the<br />
AD/DA card is fitted in the console.<br />
- 138 -
Change language