Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Steinberg Nuendo and Cubase<br />
Before using the <strong>Genesys</strong> with a Nuendo/Cubase system, please ensure<br />
that both systems are properly configured as outlined on page 25.<br />
This involves:<br />
• Setting the IP addresses on <strong>Genesys</strong> and the DAW computer.<br />
• Connecting the network ethernet cabling.<br />
• Installing the ipMIDI driver.<br />
<strong>Genesys</strong> Setup<br />
▶ Go to Settings / Services and make sure Steinberg<br />
Cubase/Nuendo is selected at the Payment within 14 days after invoice<br />
date with 2 % cash discount, or within 30 days without discount.<br />
of the screen.<br />
▶ For #1, select the MIDI Port, then the console 8 block of faders on<br />
which you wish these DAW tracks to appear.<br />
NB:<br />
The 8T faders are referred to in the pull-down list of options as Master.<br />
▶ Repeat for all the other available MIDI Ports and fader blocks on the<br />
console.<br />
NB:<br />
This mapping must match that set in Nuendo/Cubase. The same MIDI<br />
Port cannot be used more than once (including the one set for Midi<br />
Timecode). The 8 block of faders can only be linked to a single MIDI Port<br />
and not repeated.<br />
The DAW control is limited to controlling a maximum of 48<br />
Nuendo/Cubase tracks or 6 MIDI Ports (this does not include the MIDI Port<br />
used for MTC).<br />
▶ Once set, click OK. Follow the on-screen instructions to re-launch the<br />
software to apply the new changes.<br />
Nuendo/Cubase Setup<br />
▶ In your DAW open the Devices Setup dialogue from Devices menu.<br />
▶ Click the + button in the top left of the screen and select Mackie<br />
Control.<br />
You need to setup the DAW MIDI Ports in reverse order to correctly assign<br />
the DAW tracks to <strong>Genesys</strong>.<br />
The following assumes you have a 16 channel <strong>Genesys</strong> console and the<br />
<strong>Genesys</strong> software has been set to 1-8 as MIDI Port 1 and 9-16 as MIDI<br />
Port 2.<br />
▶ Change the MIDI Input and MIDI Output to 'xx. Ethernet MIDI'.<br />
Where xx is the last assigned MIDI Port in the <strong>Genesys</strong> software. In this<br />
case select '02. Ethernet MIDI'.<br />
▶ Click the Apply button.<br />
▶ Click the Reset button.<br />
▶ Click the + button and select Mackie Control.<br />
▶ Change the MIDI Input and MIDI Output to '01. Ethernet MIDI'.<br />
▶ Click Apply then click Reset.<br />
- 184 -
Change language