Genesys User Manual - AMS Neve

2T/MIX
Sends tone to the 2T and Mix Outputs, as set on the Settings screen.
The OSC routing buttons have no interlock, so is is possible to route the
oscillator to multiple destinations at once.
LS
Sends pink noise only to the loudspeaker outputs, and can only be
operated if PINK is selected
Any audio feeding the loudspeakers will be cut before the pink noise is
sent, and once in this mode, it will be possible to individually switch each
Loudspeaker CUT button on or off in order to calibrate each loudspeaker
individually.
Deselecting LS will then uncut ALL Loudspeakers to return to normal
monitoring.
OSC FRQ
Sets the frequency of the TONE oscillator.
The stepped values are:
• OFF
• 50 Hz
• 440 Hz
• 1 KHz
• 10 KHz
• 15 KHz
METERS Section
CH MTRS
Lights yellow and selects the feeds to the Channel Meters (these buttons
are latching and interlocked).
CH I/P
Lights yellow and meters the Channel Inputs, which is Post Mic/Line Input
but Pre- any processing that may be on the Channel path.
DAW SND
Lights red and meters the DAW Sends from the direct outputs of the
channels.
DAW RET
Lights green and meters the DAW Returns to the DAW monitor inputs.
- 61 -