Genesys User Manual - AMS Neve

Pin Signal name Male XLR 1 pin:
6 AES TX 1+ 2
18 AES TX 1- 3
19 screen 1
Male XLR 2 pin:
17 AES TX 2+ 2
4 AES TX 2- 3
1 screen 1
• AES 1 contains data for channels 1 (L) and 2 (R) from the 4081
• AES 2 contains data for channels 3 (L) and 4 (R) from the 4081
On the AES Ins/Outs 25-way connector on the rear of the 4081, a
number '1' printed next to the corner of the connector indicates the
location of Pin 1.
NB:
Please note that analogue breakout cables will not be suitable for
use with this connector.
Ensure you use a cable wired to the Tascam AES convention instead.
(An analogue cable is wired pin-to-pin, an AES cable has the pins crossed
so pin 1 goes to pin 25 etc).
These signals are on a 25-way D-sub connector.
25-way Pin Male XLR 1 Standard cable
6 Line Out 1 hot 2 5
18 Line Out 1 cold 3
19 screen 1
Male XLR 2
17 Line Out 2 hot 2 6
4 Line Out 2 cold 3
5 screen 1
Male XLR 3
3 Line Out 3 hot 2 7
15 Line Out 3 cold 3
16 screen 1
Male XLR 4
14 Line Out 4 hot 2 8
1 Line Out 4 cold 3
2 screen 1
Female XLR 1
12 Insert IN 1 hot 2 1
24 Insert IN 1 cold 3
25 screen 1
Female XLR 2
23 Insert IN 2 hot 2 2
10 Insert IN 2 cold 3
11 screen 1
- 162 -