Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
It is possible to tie a set of loudspeakers to the Stereo fold-down as<br />
described in ST, and also which speaker set is locked to the Sub and Left<br />
Surround / Right Surround.<br />
See section below on Master SEL Mode.<br />
S & LS/RS leds<br />
Lights red whenever B, M1 or M2 loudspeaker sets are selected with ties<br />
set, either on the LS Settings Screen or using Master SEL mode and the<br />
LS selector buttons.<br />
LS SOLO led<br />
This red led will light to show that the 6 LS CUT buttons are now in<br />
destructive mode and non-latching.<br />
This mode allows for any of the buttons to be lit by selection of any of the<br />
CUT buttons ie if you were to select L CUT, then all the rest would light<br />
(apart from L CUT).<br />
If a Master Cut is selected, it will suspend LS Solos until deselected.<br />
The setting of this mode using Master Cut can be made on the LS Settings<br />
screen, or via Master SEL Mode on the panel.<br />
L / C / R / LS / S / RS<br />
Will light red when individually selected and cut the appropriate speaker.<br />
All of these buttons will light if Master CUT is selected.<br />
If individual cuts are in place when the Master CUT is selected, these<br />
individual cuts will be reinstated when the Master CUT is turned off.<br />
Also, if some Cuts are selected or not selected when Master Cut is<br />
selected then they will remain cut or not cut even when Master Cut is<br />
deselected, allowing cuts groups to be formed.<br />
Master CUT<br />
Lights red and cuts all of the speakers.<br />
All of the individual speaker buttons will also light red. It is also possible to<br />
activate Master Cut remotely via the DC remote connector. This will switch<br />
Master Cut ON and flash the Master Cut led.<br />
DIM<br />
Lights yellow, and dims the speakers by a predetermined amount, set by<br />
the Control Room Monitoring level knob (see below).<br />
The DIM will also be forced onto the monitoring whenever the console<br />
Talkback, Producers Talkback or Slate are in use or remote dim is applied.<br />
The DIM led will flash in remote DIM.<br />
MONO<br />
Lights yellow and collapses a Stereo or Surround mix into mono.<br />
Collapsing a 5.1 mix is done in conjunction with the ST button and the 5.1<br />
MONO tick box in the settings screen.<br />
- 77 -
Change language