Genesys User Manual - AMS Neve

▶ On the next reboot the system will then recognize and display the name
of the USB disk recovery stick below this menu.
▶ If you have completed this process but the option USB Storage
Legacy Support remains disabled or was disabled when you first
entered this menu, press F10 on the keyboard, then press the Y key
and then press ENTER which will restart the process from the start.
▶ You will now need to repeat the steps from the beginning of the
recovery section again on page 195.
If this process fails after several attempts, please contact AMS Neve for
technical support.
USB Disk Selection
AwardBIOS CMOS Setup Utility
Standard CMOS Features
Miscellaneous Control
Advanced BIOS Features
Load optimized Defaults
Advanced Chipset Features
Load Standard Defaults
Integrated Peripherals
Set Supervisor Password
Power Management Setup
Set User Password
PnP/PCI Configurations
Save & Exit Setup
PC Health Status
Exit Without Saving
Esc: Quit
↑↓→ ← : Select Item
F10: Save & Exit Setup
Time, Date, Hard Disk Type...
▶ Use the Arrow keys to scroll down to Advanced BIOS Features
(highlighted above) and Press ENTER.
▶ Using the arrow keys on your keyboard, scroll down to the option Hard
Disk Boot Priority and press ENTER.
▶ A sub-menu will appear on your screen and you should scroll to the
option labeled USB-HDD0 using the Arrow keys. This option should now
be highlighted.
▶ Use the Page Up/Page Down keys to move this option into the first
position at the top of the list, i.e.
1. USB-HDD0
▶ When you have done this, press F10, then the Y key and ENTER. The
computer will now reboot.
- 198 -