Genesys User Manual - AMS Neve

PFL
Lights yellow and allows the PFL buss to be switched to the monitors
whenever a SOLO is pressed on a Channel, Monitor or 8T in Safe Mode.
It is enabled to be selected by either CH SAFE, MON SAFE or 8T SAFE
and is interlocked with SIF.
It will be temporarily cancelled if any Rev Return AFL is selected.
See main monitor pot section of the manual to set PFL level to
Monitor.
SIF
Lights yellow and allows the Solo In Front to be switched into the monitor
when Channel, Monitor, Rev AFL or 8T SOLO buttons are pressed. This
function will 'blend' this solo source with the monitor source to hear solos
in context with the main monitor selection.
It is enabled by either CH SAFE, MON SAFE or 8T SAFE and is
interlocked with PFL.
See main monitor pot section of the manual to set SIF blend level
ratio to Monitor.
M2 SEL
Lights yellow when selected and allows PFL or the RTB to be sent to the
M2 speakers if they are not being used for other monitoring purposes.
• The 1st press will send the PFL buss to M2 any time a Solo
button is pressed on the console.
• The 2nd press will set RTB to be sent to the M2 speakers.
• The 3rd press will return the M2 speakers to their default state.
The function of M2 SEL will be shown on the associated leds.
M2 SEL will be temporarily suspended if M2 LS is selected, and will return
to it's original state if M2 is deselected.
NB:
It is also possible to activate RTB remotely, via the DC Remote
connector.
This will switch on M2 SEL and flash the RTB led on the monitor panel to
show remote selection.
SWP
Lights yellow and sends the rear Left and Right speakers to the front Left
and Right, cutting the LS and RS speakers.
This enables the rear Surround image to be heard on the front speakers
for better balancing.
A, B, M1 & M2
Lights yellow when pressed and selects sets of loudspeakers.
• A and B are both Surround sets of speakers.
• M1 and M2 are both Stereo sets of speakers.
The M1 speaker outputs appear on XLRs on the rear of the console for
convenience.
- 76 -