Genesys User Manual - AMS Neve

The BAL control will still affect the feeds sent into the Cue L & R as it did
in stereo.
LEVEL
This controls the Cue output level and has a range of -∞ to 0dB.
▶ Press to enable.
• The level for the Cue send is Pre the talkback injection point;
• The on/off for the Cue is Post the talkback injection point.
When Talkback is applied to the Cues, the programme level is
automatically dimmed by 20dB.
Master SEL mode on the CUE MIX Section
To Select the Aux Feeding the Cue
▶ Press and hold down LOCK on the Main Monitor Panel, then press RTE
SEL to enter Master SEL mode.
The RTE SEL button will flash, along with all of the console SEL leds.
Most of the Cue strip controls will have their functionality blocked out,
apart from those indicated in white, left.
Pressing the Aux 1-6 knob will cycle the Auxes that feed into the Cue:
• Aux 1 / 2
• Aux 3 / 4
• Aux 5
• Aux 6
• AUX 1 / 2 + 3 / 4
• AUX 5 + 6
• AUX 1 / 2 + 5
• AUX 1 / 2 + 6
▶ Press RTE SEL to exit SEL Mode and keep this assignment.
To Set the Utility Path Feeding into the Cue
▶ Press and hold down LOCK on the Main Monitor Panel, then press RTE
SEL to enter Master SEL mode.
The RTE SEL button will flash, along with all of the console SEL leds.
Most of the Cue strip controls will have their functionality blocked out,
apart from those indicated in white, left.
Pressing the UTIL control will cycle the feed into the Utility path between
• MIX (main stereo mix)
• CRM (whatever source is selected to the Control Room Monitors)
▶ Press RTE SEL to exit SEL Mode and keep this assignment.
- 72 -