You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
setups using LOCK/RTE SEL, can be set using the Settings Screen<br />
as well, apart from setting up the 2T mixer which must be done via<br />
LOCK/RTE SEL method.<br />
TALKBACK Section<br />
Most of the Talkback functions can be accessed remotely via relays and<br />
the 5V-CTL from the back of the console on a 15-pin D-type connector.<br />
These relays & the 5V-CTL also allow the remote operation of the<br />
Loudspeaker CUTS, DIM, TALKBACK to CUE 1 / CUE 2, RED LIGHT,<br />
RTB ON and SLATE.<br />
CUE 1 & CUE 2<br />
Each of these level controls and momentary switches can be used to set<br />
the talkback level to each Cue.<br />
It has a range of -∞ to 0dB.<br />
▶ Press to enable, the adjacent led will light and send Talkback to the<br />
Cue. It will also turn on the DIM button, and the display will temporarily<br />
display the amount of dim, set by the DIM TB preset. This is located<br />
above the Monitor DIM button. It will also dim the CUE mixer level so that<br />
Talkback can clearly be heard over the Cue Mix.<br />
If RTB is on M2 SEL, then the action of talking to CUE 1 or CUE 2 will<br />
temporarily suspend RTB, whether it is selected locally or externally.<br />
As stated, it is possible to talk to the Cues externally, in which case each<br />
Cue light will flash, along with DIM, to show remote control.<br />
NB:<br />
Selecting Auto TB in the settings screen will make CUE 1 and 2<br />
latching until Play from the Transport controls is selected, at<br />
which point CUE TB is cancelled. Once Play is stopped, CUE 1 and 2<br />
will be reinstated, allowing CUE TB to continue.<br />
SLATE<br />
This level control and momentary push switch can be used to set the Slate<br />
level to Channel Output, 8T, 2T and Main Mix Outputs.<br />
It has a range of -∞ to 0dB.<br />
It will also turn on the DIM button and the monitoring will be dimmed by<br />
an amount set by TB DIM.<br />
SLATE can also be set to include tone from the oscillator to provide a tape<br />
oscillator slate (this is done via the Settings screen, by ticking Osc With<br />
Slate).<br />
If this is the case, when pressing the Slate knob, it will also be sent to CH,<br />
8T and 2T/MIX.<br />
As stated, it is possible to Slate the console Outputs by external operation,<br />
in which case the SLATE light will flash along with DIM to show remote<br />
control.<br />
If RTB is on M2, then Slating will also temporarily suspend the RTB<br />
Talkback.<br />
TB<br />
This level control and momentary push switch can be used to set Talkback<br />
level and to talk to the TB Output jack on the rear of the console.<br />
- 83 -
Change language