Genesys User Manual - AMS Neve

Master Card ID 1 switch ID 0 switch
1 0 0
2 0 1
3 1 0
4 1 1
These IDs are used by the Board Mapping software window to determine
which physical positions the Master cards occupy.
1-8 9-16 17-24 25-32 Monitor 33-40 41-48 49-56 57-64
section
Master 1 Slave Master 2 Slave Master 3 Slave Master 4 Slave
ID: 0 0 0 1 1 0 1 1
It is only the Master card that needs to have its position within the console
set.
In the diagram above, each numbered Master card is shown with its Slave
in position on a 64-fader console, along with the ID switch settings for
each Master card.
Please note, this is a typical configuration and customers may decide to
put Master cards in different positions.
The Monitor Section card does not require ID switches to be set.
Once you have set these ID switches, please see the section on Board
Mapping on page 147.
WCLCK 75Ω Termination
Set this switch to the up position if you have Wordclock sync coming into
this card.
This will terminate the Wordclock input signal.
- 128 -