Genesys User Manual - AMS Neve

AUX MASTERS Section
Master Send
Sets the Master Send level for each Aux, and runs from –∞ to 0dB.
▶ Press to toggle the Master Send on or off.
The adjacent led will light to show the send is On.
MIX Section
IMR
Sets and controls the Insert Mix Return level.
▶ Press to enable (the led will light).
When using the IMR Insert across the Main Mix Output, it is possible to
listen to a mix of the Main Output and the Insert Mix Return.
This control has a range of 0% of IMR (hard Left) to 100% of IMR (hard
Right).
If this control is not enabled, you will hear 100% of the main insert Return
signal.
PRE
▶ Sets whether the Insert is patched Pre- or Post- the Main Mix fader.
INS
▶ Switches the Insert In/Out of circuit.
HEADPHONES Section
Master Send
Sets the level and source of the feed to the headphone jack-socket,
situated on the underside of the console buffer near the Master Mix fader.
The push switch is a 4-state toggle:
• Defaults to CRM (where the headphone feed follows whichever
source is selected to the Left and Right Control Room Monitors)
• EXT (where whichever External is selected on the Control Room
Monitor panel is sent to the headphones. If a Surround External is
selected, then just the Left and Right will be sent)
• CUE 1 Output (L & R)
• CUE 2 Output (L & R)
- 57 -