Genesys User Manual - AMS Neve

Faders & Keypad
Channel Faders
Each fader has a range of -∞ to +10dB, with it's own CUT and SOLO
button.
There are two types of faders, motorised and manual. The motorised
faders are used by DAW Control and Encore Automation. Depending on
your console you will have either the manual or motorised faders fitted
below all the channel strips.
CUT
Cuts the paths audio.
In Mix Mode, Pre-fade contributions to Auxes will be affected by the CUT.
SOLO
A Channel SOLO will override any CUT that is already in place.
Alpha Display
Only available on Automation faders.
The four-character alpha display above each fader is used to display:
• The automation modes;
• DAW track information;
• User path-names.
SEL / GLIDE
Only available on Automation faders.
SEL: Allows you to select the automation modes locally.
GLIDE: Used for manually locally gliding back faders to the previous play
pass.
Master Faders
The 8T faders (Master faders) can either control the
8T fader levels or a block of 8 DAW faders (the red
led underneath the faders will light when DAW
control has been established).
The main output fader always controls the Main Mix
Output.
- 88 -