Genesys User Manual - AMS Neve

earlier versions of hardware it could also be routed to 8T 7 & 8 as
well).
(This is a hybrid state designed to work when the console is
working in Stereo Pan, Surround and group modes.)
It can also be used to set up local routing in conjunction with the SEL
button.
>8T on later consoles
This button is now used to show (interrogate) if any >8T's are routed
from the monitor path, selecting >8T will display the monitor routing in
the Meter up stand on the 8T leds.
SWP
Swaps the large Fader & Cut with the Small monitor knob & Cut within the
Channel and Monitor paths.
It will also swap mix data when Automation is present.
SOLO
Solos the path in either Momentary, Latching or Interlock mode.
CUT
Cuts the path's audio. And also cuts the pre fade auxes in Mixdown mode.
The CUT can be temporarily over-written by the adjacent SOLO button,
and if automation events have been written.
TO MON leds
Indicates the status of processing.
If any of the INS1, INS2, DYN or EQ leds are lit, this indicates a process
present and switched in circuit on the Monitor path.
The order of the channel processing can be set in SEL Mode and the ORD
screen.
Preventing feedback loops
There are circumstances under which it is possible to create a feedback
loop on the console.
• If the Direct Output is fed from the Monitor (either Pre- or
Post-) and you set the Monitor Input to DAW SND, or
• The Monitor path is set to DAW SND and you set the Direct
Output to Monitor (Pre- or Post-).
To combat this, the console will take steps to prevent this from happening.
• When you toggle through the inputs of the Monitor path, the DAW
Send will not be available, and the DAW SND led will flash twice
without changing from DAW RET.
• If you have DAW SND set, and you toggle through the Direct
Outputs, when you reach Monitor (either Pre- or Post-), the
DAW selection will be forced to RET.
- 54 -