You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
When enabled, this will take the DLN input, and feed it into the DAW<br />
RTN path, meaning that the digital line input can be monitored through<br />
the Monitor section.<br />
If DAW is selected at the top of the channel strip when this option is<br />
ticked, this input will be forced into DLN to prevent possible feedback.<br />
Similarly, with this option ticked, DAW cannot be select as an input.<br />
Instead, when you toggle round the options by pressing the Trim pot, the<br />
DAW led will flash once to show it cannot be selected, and the input will<br />
be set to the next available selection.<br />
Power Up<br />
On power-up, the console can be set to one of four states:<br />
Default<br />
This is the <strong>AMS</strong> <strong>Neve</strong> default Read-Only setup (loads the 2T MIX setup).<br />
As Was<br />
The console takes a snapshot of itself between every five to sixty minutes<br />
(including all routing, pre/post states etc), and it is this snapshot that will<br />
be loaded when the console is first powered up.<br />
See the Settings / Services sub-section of the manual for details on<br />
setting up the As Was snapshot frequency.<br />
Last Store Made<br />
Loads the last store that was created.<br />
NB: this is the last store Saved, not the last one Loaded.<br />
Custom Store<br />
The user can set up a default store and have this loaded every time the<br />
console powers-up as a custom starting template.<br />
These four options are interlocked.<br />
OSC<br />
Osc With Slate<br />
Sends osc tone with the Talkback when Slate is selected.<br />
Osc to 2T<br />
Without this option ticked, enabling the Tone and pressing the 2T/MIX<br />
button will only send tone to MIX.<br />
With this option ticked, Tone will be sent to both the MIX and 2T busses<br />
Setups<br />
Set by Store<br />
This allows the settings for LS Settings, 8T Solo Linking, Osc and Tie Ch<br />
SEL to be reset if a store is loaded with different data from Power Up, or if<br />
new stores are loaded.<br />
If this option is unticked, then these settings will remain unchanged on<br />
Reset.<br />
Calibrate<br />
Allows you to calibrate all of the audio paths on the console with up to +/-<br />
1.5dB of trim.<br />
Click any of the top row of buttons to select the path type (these buttons<br />
are interlocked).<br />
- 106 -
Change language