Genesys User Manual - AMS Neve

CAT 5 connections on systems without AD/DA Monitor card
Channel Slave Audio Link Channel Slave Audio Link Channel Slave Audio Link Channel Slave Audio Link
1 2 3 1 2 3 1 2 3 1 2 3 1 2 3 1 2 3 1 2 3 1 2 3
1 - 8 9 – 16 17 – 24 25 – 32 33 – 40 41 – 48 49 – 56 57 - 64
Master Slave Master Slave Master Slave Master Slave
In Out In Out In Out In
Genesys
computer
USB to CAT5 converter cable – into the first Serial In on 17-24 Master
card, then out of Serial Out, into Serial In on 1-8, out of Serial Out, to Serial In on
33-40 and so on.
On a system without a Monitor card, the comms goes from the Genesys
computers into the 17-24 Master card, then this signal goes to 1-8, 33-40
and finally 49-56.
Wordclock Sync
In Out*
1 - 8 9 – 16 17 – 24 25 – 32 Monitoring 33 – 40 41 – 48 49 – 56 57 - 64
Master Slave Master Slave Master Slave Master Slave
The Wordclock Sync can only be accepted by the left-hand most Master
card (or the Monitor card if this is left-most) using the WCLK IN BNC
connector.
This Wordclock sync is then internally distributed from this single point to
all the other cards in the system.
The Wordclock sync is also output (on the adjacent WCLK OUT BNC
connector) should it be needed to feed other pieces of equipment.
* If the WCLK OUT connector is used, it should be terminated by setting
the 75Ω switch as shown on page 127.
- 141 -