Genesys User Manual - AMS Neve

To Lock Relative Levels Within a Loudspeaker Set
It is possible to apply +/-10dB of trim to each loudspeaker feed within
each speaker set.
▶ Press and hold down LOCK on the Main Monitor Panel, then press RTE
SEL to enter Master SEL mode.
The RTE SEL button will flash, along with all of the console SEL leds.
Most of the Monitor Panels buttons will have their functionality blocked
out.
▶ Select the loudspeaker set, either A, B, M1 or M2 (the button will
flash).
▶ Using the loudspeaker CUT buttons, select the element you wish to
alter, either L, C, R, LS, S or RS (the button will flash when pressed).
That path's Trim value will now be shown in the Control Room alpha
display with a range of +/- 10dB and in the Settings Screen display.
▶ Turn the monitoring knob to set this value.
▶ Either select another loudspeaker, or exit Master SEL Mode to lock these
Trims in place.
To Lock the S and LS/RS to Sets of Loudspeakers
It is possible to lock both the Left Surround and Right Surround speakers,
and/or the Sub to a specific set of Surround speakers.
▶ Press and hold down LOCK on the Main Monitor Panel, then press RTE
SEL to enter Master SEL mode. All of the console SEL leds will flash.
Most of the Monitor Panels buttons will have their functionality blocked
out.
▶ Select either B, M1 or M2 (the button will flash).
It will now be possible to lock the S and/or the LS/RS to the selected set
of loudspeakers.
For each press of the Monitor pot as the route is made, the alpha display
will show:
• S: Sub
• LSRS: Left Surround and Right Surround
• LRSS: Left Surround, Right Surround and Sub
• OFF: No speaker locks in place
▶ Once set, press RTE SEL to exit Master SEL Mode to lock these
assignments into place.
- 81 -