Genesys User Manual - AMS Neve

DIRECT OUTPUT Section
Master Level
Sets the level of the Direct Output, and has a range of -∞ to +10dB.
In it's default state there will be no output and all of the associated leds
will be unlit (Off).
The control is a 6-state toggle, and pressing it will cycle the Direct Output
to be fed from (1 st press):
• Channel input, Pre processing, Pre fader, Pre CUT (PRE led lit)
• Channel input, Post processing, Pre fader, Pre CUT (PRE & CH
leds lit)
• Channel input Post processing, Post fader, Post CUT (CH led lit)
• Monitor input, Post processing, Pre fader, Pre CUT (PRE & MON
leds lit)
• Monitor input, Post processing, Post fader, Post CUT (MON led
lit)
• OFF (all leds unlit)
NB:
When in Mix mode the Channel input selection is not possible so as
to prevent feedback via the DAW (the PRE led will flash to indicate
this).
Please note:
In early versions of software, this control will work in a slightly different
manner as it will always be in circuit, taking it's feed from the Channel
Input (with no leds lit to indicate this selection).
However, the subsequent toggle cycle of:
• Ch Pre
• Ch Post
• Mon Pre
• Mon Post
is still preserved.
- 51 -