Genesys User Manual - AMS Neve

AES Sync
In
(Out)
DSub2
1 - 8 9 – 16 17 – 24 25 – 32 Monitoring 33 – 40 41 – 48 49 – 56 57 - 64
Master Slave Master Slave Master Slave Master Slave
The card receiving the AES Sync is set on the main Configurator screen
Please go to page 148 to see how this is set.
This AES sync is then internally distributed from this single point to all the
other cards in the system.
This same AES sync is then output on connector 7 on the same D-Sub
connector should it be needed for other pieces of equipment.
Unlike WCLK sync, AES sync does not need terminating if the Output is
unused.
AES Ch 1/2 Sync
In
DSub1
1 - 8 9 – 16 17 – 24 25 – 32 Monitoring 33 – 40 41 – 48 49 – 56 57 - 64
Master Slave Master Slave Master Slave Master Slave
The AES sync can be derived from the AES channels 1 and 2 Line audio
input using XLR connector 1.
This has the advantage of not needing an extra cable to supply just the
sync.
To set which of the cards receives the AES Channel 1&2 Sync, please go
to the main software Configuration screen on page 148 to see how this is
set.
If you wish to take the sync input by the same method by on the Monitor
card instead, the AES sync is derived from the DEXT L&R input signal.
- 142 -