Genesys User Manual - AMS Neve

Optional Software Packages
Automation
When a console has the optional automation package fitted, it comes with
the following additions to a standard console:
• The Encore Plus automation software to record, edit and play back
automation of Faders, Cuts and Channel Events (Aux On/Off, Insert
On/Off etc).
• Motorised channel faders & monitor faders, enabling playback of
automated moves.
• A row of Master Automation buttons next to the Main Output faders
for setting the automation modes.
• Extra SEL and GLIDE buttons above the faders
For the operation of the Encore automation software, please see the
separate Encore Automation User Manual (part number 527-390).
Recall
The Recall package means that as well as taking snapshots of the console
surface as you would on a standard console (including any internal
routing), the Recall software allows you to record the positions of all
rotary controls, switch states and non-automated faders so they can be
manually matched at a later date providing full console reset ability.
It does not need any specific hardware to run other than that supplied
with a standard console.
As each control is matched by hand, an on-screen graphic will display the
position of the control as you set it, plus an indication of where the control
should actually be (indicated by a purple mark).
Once it has been matched, the next control will be displayed and so on,
until all of the surface has been reset.
• If Recall has been fitted, a letter 'R' will be displayed in red in the top
right corner of the main screen just by the timecode display.
Recall Stores are stored by default in the same location as any Automation
files (for ease of use) but they can be stored in any user-defined location
on the system.
For the purposes of this manual, it has been presumed that the Recall
package has been installed.
Please see chapter on Recall.
For more information on optional software & hardware,
please contact your local Neve distributor.
- 23 -