Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Speaker Trims<br />
▶ Click the speaker set button you wish to set the Trims for (A, B, M1 or<br />
M2).<br />
For each of the six speakers, you now have +/-10dB of Trim to apply in<br />
0.1dB steps.<br />
▶ Use the up/down arrows to scroll the value for each speaker.<br />
8T Solo Linking<br />
Channel to 8T<br />
If ticked, the Channel Solos are linked to the 8T Solos, so that pressing<br />
any Channel SOLO will also cut the 8Ts (and all the 8T CUT leds will<br />
light).<br />
If unticked, the 8Ts are safe from the Solo system.<br />
Monitor to 8T<br />
If ticked, the Monitor Solos are linked to the 8T Solos, so that pressing<br />
any Monitor SOLO will also cut the 8Ts (and all the 8T CUT leds will light).<br />
If unticked, the 8Ts are safe from the Solo system.<br />
8T<br />
If ticked, means the 8T busses are safe, so the 8T Mix is not affected<br />
whenever an 8T SOLO is pressed.<br />
If unticked, the Solo is destructive, and all of the other 8T busses are put<br />
into Cut (and all of their CUT leds will light).<br />
Other Options<br />
AUTO TB (with Play Delay)<br />
Sets CUE 1 and 2 (Talkback, see page 83) to latching until Play is selected<br />
from the Transport controls, at which point CUE TB is cancelled<br />
immediately. The Play command is transmitted after the delay (in<br />
seconds) has elapsed. Once Play is stopped, CUE 1 and 2 will be<br />
reinstated, allowing CUE TB to continue with constant hands-free<br />
communication to the TB destinations.<br />
TB Latch<br />
Interlocked with Auto TB. If ticked will turn CUE 1 and CUE 2 from<br />
momentary to latching, even if Play is being cycled on the DAW. Remote<br />
operation of the CUES will also be changed from momentary to latching in<br />
TB Latch mode.<br />
TB Output Enable<br />
This control if ticked will allow CUE1 and CUE2 to turn on the TB Relay<br />
allowing for an extra TB level control output to be sent to the studio TB<br />
system.<br />
Lock Monitor Level<br />
When enabled, this prevents the large main monitor knob from being able<br />
to set the DIM/ AFL / PFL / SIF values, so pressing the knob will not light<br />
any of the leds underneath, nor allow you to change their settings.<br />
DLine Enable<br />
Only applicable on consoles that are fitted with at least one Channel<br />
AD/DA cassette.<br />
- 105 -
Change language