You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
CUE MIX Section<br />
Each of the Cue mixes can be sourced from:<br />
• A stereo External<br />
• Either the Main Mix or the current Control Room Monitor selection<br />
(set by UTIL knob)<br />
• Four mono Auxes or two stereo Aux.<br />
EXT 1-4<br />
This level pot and switch controls the currently selected External level into<br />
the Cue.<br />
If you have either of the Surround Externals selected, it will only send the<br />
Left and Right to the Cue.<br />
It has a range of –∞ to 0db.<br />
▶ Press to enable.<br />
UTIL<br />
This level pot and switch controls the Main Mix or the current Control<br />
Room Monitoring level into the Cue, the selection being indicated by the<br />
adjacent leds.<br />
It has a range of –∞ to 0dB.<br />
▶ Press to enable.<br />
NB. The selection of main mix or CRM is set in Master SEL mode.<br />
AUX 1-6<br />
This level control and switch controls the Aux contribution to the Cue mix.<br />
▶ Press to enable.<br />
• When Aux 1 / 2 is selected, this will feed 1 to L & 2 to R.<br />
• When Aux 3 / 4 is selected, this will feed 3 to L & 4 to R.<br />
• When Aux 5 is selected, this will feed to L & R.<br />
• When Aux 6 is selected, this will feed to L & R.<br />
• When AUX 1 /2 and 3 / 4 are selected this will feed 1 and 3 to L and 2<br />
and 4 to R.<br />
• When AUX 5 and 6 are selected, this will feed 5 to L & R and 6 to L & R.<br />
• When AUX 1 / 2 and 5 are selected, this will feed this will feed 1 to L<br />
and 2 to R and 5 to L & R.<br />
• When AUX 1 / 2 and 6 are selected, this will feed this will feed 1 to L<br />
and 2 to R and 6 to L & R.<br />
NB. The selection of Auxes is set in Master SEL mode.<br />
TILT EQ<br />
Has no On/Off switch associated, but the rotary control has a centre<br />
detent to indicate a flat response.<br />
It is used to brighten or dull the Cue mix being fed to the headphones, by<br />
boosting either the higher or lower frequencies.<br />
The TILT EQ control is stereo and has a range of +/-4dB @ 1.2 kHz.<br />
It is possible to use a<br />
single Cue in stereo, or<br />
as two mono by hardpanning<br />
the stereo<br />
sources sent to it.<br />
BAL<br />
This balances the Left and the Right of the Cue, and is in circuit all of the<br />
time.<br />
It has a range of +/-6dB.<br />
▶ Press the control to make the path mono (the MONO led will light).<br />
- 71 -