Genesys User Manual - AMS Neve

RTE
This screen is a graphic representation of the internal routing of the
console and is shown whenever the RTE SEL button is pressed
(depending on how this Preference is set up in the Settings screen).
If this screen is open when routes are made on the console, the screen
will reflect this.
▶ Likewise, it is possible to click on-screen in the relevant junctions to put
these routes in place on the console if this is preferred.
Depending on the channel strips installed, the following may apply.
▶ If you wish to route all of the Channel Inputs (or DAW Returns) to the
Main Mix buss, click the CH MIX (or MON MIX) button and all of those
routes will be put in place for every channel on the console.
▶ If you wish to route all of the Channel Inputs (or Monitor Inputs) to the
Main Mix buss, select the relevant tab, then click MIX L/R.
▶ If you wish to turn on the LCR Pans for all the Channel Inputs (or
Monitor Inputs) select the relevant tab, then click LCR.
• A yellow block indicates a Mono or Stereo route in place
• A yellow & red block indicates a route in place using the LCR Pan law.
Unavailable routes will be greyed out.
- 111 -