You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Master SEL mode<br />
▶ Master SEL mode is entered, by holding down the LOCK button on the<br />
Main Monitor Panel, and then pressing RTE SEL.<br />
All of the SEL buttons on the Channel and 8T strips will flash to indicate<br />
the console is in Master SEL mode.<br />
This is purely a setup mode that allows you to set the Pre/Post state of<br />
auxes, set loudspeaker locks, the order of processing on the channels etc.<br />
Once in Master SEL mode, the majority of the console's audio functionality<br />
is blocked out.<br />
NOTE<br />
In this Mode, with the LCR type module fitted, it will be possible to<br />
tell which CH modules are transformer type using the CHM led<br />
below the Mic encoder display:<br />
1 CHM led not flashing – electronic mic input<br />
2 CHM led flashing – transformer mic input<br />
In this manual, all text relating to Master SEL mode is shown with a<br />
shaded background.<br />
▶ Exit Master SEL mode by pressing RTE SEL.<br />
Master SEL Mode on the Channel Strip<br />
When in Master SEL mode, most of that strips functionality plus the<br />
ability to change any of the audio is suspended.<br />
The SEL led will flash to indicate you are in Master SEL Mode.<br />
It will then be possible to set up Auxiliary Pre-/Post- states, selecting<br />
INS1, INS2, EQ or DYN in the CH or MON path and ordering the<br />
processing.<br />
Also, indication of transformer and non transformer LCR modules will be<br />
shown as well, using the CHM led below the mic gain control.<br />
Master SEL Mode on the 8T Section<br />
When Master SEL mode is on the 8T faders section, you can set how the<br />
8T signals are fed into the Auxes (either Pre- or Post-), and how the Rev<br />
sends are fed to the Cues (either Pre- or Post-).<br />
In the last case, it will be possible to adjust the Rev Input level at the<br />
same so it will be possible to audition this audio.<br />
Master SEL Mode on the Monitor Panel<br />
On the Monitor Panel, Master SEL mode will launch the Settings screen,<br />
and will let you define Util & Aux Cue feed sources, Solo modes, powerup<br />
defaults etc.<br />
The majority of these functions can also be configured on the Settings<br />
Screen (see separate chapter).<br />
- 33 -
Change language